SSH Connection Reset: Peer on ZeroTier 'Birch' Node

Here is the article as per your requirements:

Title: Connecting Two Systems in a Home Network: A Guide to ZeroTier Birch Node

Introduction:

In this article, we will guide you through the process of connecting two systems in a home network using ZeroTier's Birch node. If you have been successfully SSHing into your systems for months, and recently installed ZeroTier, you might be wondering how to utilize another node. This guide will help you understand the key concepts and provide a detailed context on connecting the nodes.

Understanding ZeroTier and Birch Node

ZeroTier is a network virtualization software that allows you to create, manage, and connect private networks over the internet. The Birch node is a part of the ZeroTier ecosystem, designed to simplify the process of creating and managing networks.

Installing and Configuring Birch Node

Before you start, ensure that both systems have ZeroTier installed. To install Birch node, follow these steps:

1. Install ZeroTier on both systems.

2. Run the following command on the system you want to turn into a Birch node:

   zt-ctl birch join <your-network-id>
   

   Replace <your-network-id> with the ID of your ZeroTier network.

3. On the other system, run the following command to get the IP address of the Birch node:

   zt-ctl birch list
   

   Note down the IP address of the Birch node.

Connecting the Systems

Now that you have the IP address of the Birch node, you can connect the systems:

1. On the system that is not the Birch node, run the following command to join the network:

   zt-ctl join <your-network-id> <Birch-node-IP>
   

   Replace <your-network-id> with the ID of your ZeroTier network and <Birch-node-IP> with the IP address of the Birch node.

2. Verify the connection by checking the network status:

   zt-ctl status
   

Code Block Example

Let's say you have a system with IP address 192.168.1.1 and you want to turn it into a Birch node. The command to join the network would be:

zt-ctl birch join 1234567890abcdef1234567890abcdef192.168.1.1

References

• ZeroTier Documentation: https://docs.zerotier.com/
• ZeroTier GitHub: https://github.com/ZeroTier/ZeroTierOne
• ZeroTier Blog: https://blog.zerotier.com/

Summary:

In this article, we discussed connecting two systems in a home network using ZeroTier's Birch node. We covered the installation and configuration of the Birch node, and the process of connecting the systems. By following this guide, you should be able to set up a private network over the internet, simplifying data sharing and communication between your systems.