Problem Assembling Hardware RAID 1 Drive After Changing Motherboard
Symptoms
After changing the motherboard, the RAID Xpert 2 software keeps scanning the drive but it is not shown in the Windows Device Manager. Several restarts have been performed, but the issue persists.
Troubleshooting Steps
- Ensure that all RAID cables are securely connected to the motherboard and drives.
- Check the BIOS settings to ensure that the RAID is enabled and set to the correct mode (RAID 1 in this case).
- Make sure that the drives are recognized by the BIOS.
- Perform a clean boot to eliminate potential conflicts with third-party software.
- Update the RAID Xpert 2 software to the latest version.
- Reinstall the RAID drivers.
- Check the Windows Event Viewer for any error messages related to the RAID drives.
Code Block (Example in C#)
// Example code in C# for RAID 1 configuration
RaidController raidController = RaidController.GetInstance();
RaidArray raidArray = raidController.CreateArray(ArrayType.RAID1, 2);
// Add drives to the RAID array
Drive[] drives = raidController.GetDrives();
foreach (Drive drive in drives)
{
if (drive.IsReady)
{
raidArray.AddDrive(drive);
}
}
// Initialize the RAID array
raidArray.Initialize();