Here's a comprehensive guide for newbies who need to install a 80GB SATA HDD on Fedora 29 (FC29) with UEFI and AHCI enabled, as their system can't see the HDD.
Introduction
In this guide, we will walk you through the process of installing a 80GB SATA HDD on Fedora 29 (FC29) with UEFI and AHCI enabled. If your system can't see the HDD, don't worry, we've got you covered.
Prerequisites
- A system with UEFI and AHCI enabled
- A 80GB SATA HDD
- Fedora 29 (FC29) installation media
Step 1: Boot into Fedora Live Environment
Insert the Fedora 29 live media into your system and boot from it.
Step 2: Access the BIOS
After booting into the live environment, you'll need to access the BIOS. The key to access the BIOS varies between systems, but it's usually either F2, F10, F12, or Esc.
Step 3: Enable AHCI
In the BIOS, navigate to the SATA configuration settings and ensure AHCI is enabled. Save and exit the BIOS.
Step 4: Install Fedora 29
Now, you can proceed with the Fedora 29 installation. During the installation process, select the custom installation option.
Step 5: Partition the HDD
Next, select the newly installed HDD and click on "New". Create partitions as per your requirements. Remember to create at least one partition for the root file system, one for swap, and one for the home directory.
Step 6: Install Fedora 29
After partitioning, you can proceed with the Fedora 29 installation. Select the partitions you created earlier for the root file system, swap, and home directory.
Step 7: Boot the Installed System
Once the installation is complete, reboot your system. If everything is set up correctly, you should be able to boot into your newly installed Fedora 29 system.
Troubleshooting
If you still can't see the HDD after following these steps, there might be a problem with the HDD itself or with the SATA port. Try using the HDD in another system to rule out the possibility of a faulty HDD. If the HDD works in another system, the problem might be with the SATA port.
References