Network Issues: Router (Standard Sky Router) and WAX204 AP (Raspberry Pi Session Freezing with Certain Commands)
This article focuses on network issues that may arise when using a Standard Sky Router and a Netgear WAX204 Access Point configured in access point mode. Specifically, we will address the problem of peripherals hanging and sessions freezing when certain commands are executed on the Raspberry Pi.
1. Introduction
When setting up a network, it is common to use a router and one or more access points to extend the wireless coverage. In this scenario, we will discuss the Standard Sky Router and the Netgear WAX204 Access Point. The WAX204 AP is connected to the router via a single port and is configured in access point mode. However, users may encounter issues where peripherals connected to the network freeze or sessions on the Raspberry Pi terminate when executing specific commands.
2. Troubleshooting Peripherals Hanging and Raspberry Pi Session Freezing
The following steps can be taken to troubleshoot and resolve the network issues related to peripherals hanging and Raspberry Pi session freezing:
Check the network configuration to ensure that the Standard Sky Router and the Netgear WAX204 AP are properly set up and connected.
Update the firmware on both the router and the access point to the latest version available.
Check for any potential interference from other wireless networks or devices that may be causing issues with the network connection.
Try resetting both the router and the access point to their default settings and reconfiguring them from scratch.
Monitor the network traffic and CPU usage on the Raspberry Pi to identify any potential bottlenecks or resource constraints that may be causing the sessions to freeze.
Try using a different cable to connect the WAX204 AP to the router, as a faulty cable may be causing the issue.
3. Code Block: Example of Network Configuration
The following is an example of a network configuration that may be used with the Standard Sky Router and the Netgear WAX204 AP:
Router> enable
Router# configure terminal
Router(config)> interface fastEthernet 0/1
Router(config-if)> ip address 192.168.1.1 255.255.255.0
Router(config-if)> no shutdown
Router(config-if)> exit
Router(config)> interface wireless-ap 1
Router(config-if)> ssid mynetwork
Router(config-if)> channel 11
Router(config-if)> station-role root
Router(config-if)> exit
Router(config)> wireless-controller
Router(config-controller)> mode local
Router(config-controller)> exit
Router(config)> end
4. References
Book: Cisco Networking Technologies: Volume 1 (CCNP Routing and Switching 300-101 ROUTE)
Article: Configuring a Wireless LAN Controller on a Catalyst 9100 Series Switch
Online Resource: Netgear WAX204 Access Point Downloads
By following the steps outlined in this article, users should be able to resolve the network issues related to peripherals hanging and Raspberry Pi session freezing when using a Standard Sky Router and a Netgear WAX204 Access Point configured in access point mode.